Aller au contenu principal

Reemplazo de la placa lógica del iPad Air LTE

Info : Vous modifiez un tutoriel prérequis. Toutes les modifications apportées affecteront les 2 tutoriels qui comprennent cette étape.

Anglais
Espagnol

Traduction de l’étape 28

Étape 28
iPad Air LTE Logic Board Replacement: étape 0, image 1 de 3 iPad Air LTE Logic Board Replacement: étape 0, image 2 de 3 iPad Air LTE Logic Board Replacement: étape 0, image 3 de 3
  • As you complete the next few steps, prying adhesive securing the logic board in place, always start by testing gently to see if the adhesive is softened. If not, reheat the iOpener and reapply it to the back of the rear case.

  • Carefully insert an opening pick under the logic board, between the front-facing camera and the battery.

  • Be sure to insert the pick over the the antenna cable that runs along the length of the battery.

  • Slide the guitar pick toward the front-facing camera connector, and stop at the bend in the logic board.

Mientras realizas los siguientes pasos, despegando el adhesivo que fija la placa lógica en su lugar, comienza siempre probando suavemente para ver si el adhesivo se ha ablandado. Si no es así, recalienta el iOpener y vuelve a aplicarlo en la parte posterior de la carcasa trasera.

Introduce con cuidado una púa de apertura bajo la placa lógica, entre la cámara frontal y la batería.

Asegúrate de insertar la púa sobre el cable de antena que discurre a lo largo de la batería.

Desliza la púa de guitarra hacia el conector de la cámara frontal y deténte en la curva de la placa lógica.

Vos contributions sont faites dans le cadre de la licence open source Creative Commons.