LG GW300 Teardown

Rédigé par : James (et 2 autres contributeurs)

Publication : May 11, 2014

Tutoriel réalisé par la communauté

Commentaires : 1
Favoris : 3
Vues : 1,4k

LG GW300 Teardown

Rédigé par : James (et 2 autres contributeurs)

Publication : May 11, 2014

Tutoriel réalisé par la communauté

Commentaires : 1
Favoris : 3
Vues : 1,4k

Vue éclatée

Introduction

Passez à l'étape 1

I have tried to include as much detail as possible in this teardown. I have even inspected the chips on the mainboard! Thanks for looking, and I hope you find this useful.

Ce dont vous avez besoin

Outils

Pro Tech Toolkit
Sale price $74.95

Cette vue éclatée n'est pas un tutoriel de réparation. Pour réparer votre LG GW300, utilisez notre manuel de réparation.

Étape 1 LG GW300 Teardown

LG GW300 Teardown, LG GW300 Teardown: étape 1, image 1 de 1

Found this phone lying around, so decided to make a teardown of it!

Traduire

Étape 2

First, remove the backplate by pushing the button at the top of the back of the phone.

Traduire

Étape 3

LG GW300 Teardown: étape 3, image 3 de 3

From here there are six screws we have to remove.
But first... lemme take a battery out!

Traduire

Étape 4

Get a thin opening tool and slide it around the bezel of the device.
Make sure you put it in the correct place, behind the silver bezel of the front of the phone!

Traduire

Étape 5

The front and back of the device should separate.
Two buttons should come off after you have removed the back.
This is the rear speaker.

Traduire

Étape 6

LG GW300 Teardown: étape 6, image 3 de 3

Both of these buttons need to be pried from the front casing to allow the mainboard to come away from the front housing.
These buttons are soldered to the mainboard so make sure you don't break them!
The front speaker also has to be pried from the front housing.

Traduire

Étape 7

The main board can then be lifted from the front housing.

Traduire

Étape 8

The buttons on the front housing can then be pushed out through the back of the housing.

Traduire

Étape 9

The EMI shield can be removed by unclipping the clips on the side of the device.

Traduire

Étape 10

In the centre of the picture is the vibration module. It can be unclipped to remove it.

Traduire

Étape 11

LG GW300 Teardown: étape 11, image 3 de 3

The LCD ribbon cable and connector are under a plastic sheet that has to be removed.
The ribbon cable can then be take out of the connector
The ribbon connector is very fragile, so be careful when lifting the lever.