Canon PowerShot SD400 LCD Replacement

Yi Huang Ke et 12 autres contributeurs

Dernière mise à jour le October 14, 2024

Aucune estimation

Modérée

Étapes à raccourcir

Outils incorrects

Problème de balise

Étapes manquantes

Détails manquants

Introduction

Passez à l'étape 1

This guide offers detailed, step-by-step instructions for replacing a faulty LCD screen on your Canon PowerShot SD400. The LCD, or liquid crystal display, serves as the camera's monitor for images, and it may require replacement if you notice cracks, discolored pixels, spots, blobs, flickering, or a complete loss of image signal. Before you get started, make sure to power off the camera and remove the battery.

Ce dont vous avez besoin

Outils

Phillips #00 Screwdriver

Étape 1 Battery

Canon PowerShot SD400 LCD Replacement, Battery: étape 1, image 1 de 2

Canon PowerShot SD400 LCD Replacement, Battery: étape 1, image 2 de 2

Slide the battery cover open (indicated by the blue box).

Traduire

Étape 2

Push in the orange clip (indicated by the blue box) to eject the battery.

Traduire

Étape 3

Insert the charged battery back into the slot (indicated by the blue box).
Close the cover.

Traduire

Étape 4 LCD

Canon PowerShot SD400 LCD Replacement, LCD: étape 4, image 1 de 3

Canon PowerShot SD400 LCD Replacement, LCD: étape 4, image 2 de 3

Canon PowerShot SD400 LCD Replacement, LCD: étape 4, image 3 de 3

Locate these six screws that need to be removed to open the camera’s housing. These screws can be found on the bottom and both sides of the camera.

Traduire

Étape 5

Canon PowerShot SD400 LCD Replacement: étape 5, image 3 de 3

Using the screwdriver, carefully remove the exterior screws and place them in a safe location to avoid misplacing them.

Traduire

Étape 6

Locate the interior screw that is above the top right of the LCD screen.
Remove the screw using the screwdriver.

Traduire

Étape 7

Canon PowerShot SD400 LCD Replacement: étape 7, image 3 de 3

Locate the two clips on the left side of the LCD screen.
Carefully insert the tip of a flat-head screwdriver under the two clips of the LCD screen.
Slowly lift the screen using the flat-head screwdriver.
Potential for device damage Lift the screen gently to avoid any damage.