MacBook Air 13" Early 2017 Right Speaker Replacement

Dernière mise à jour le March 14, 2022

15 - 35 minutes

Modérée

Introduction

Use this guide to replace the right-hand speaker in your MacBook Air 13" Early 2017. This guide shows you how to replace the speaker that is on the right during normal operation, but during the guide it will often be on the left side. Be sure you are replacing the correct speaker, and have the correct part.

Ce dont vous avez besoin

Pièces

MacBook Air 13" (Mid 2011 to Early 2015) Right Speaker

Outils

Afficher plus…

Étape 1 Lower Case

MacBook Air 13" Early 2017 Right Speaker Replacement, Lower Case: étape 1, image 1 de 1

Outil utilisé dans cette étape :

P5 Pentalobe Screwdriver Retina MacBook Pro and Air

$5.99

Ajouter au panier

Before proceeding, power down your MacBook. Close the display and lay it on a soft surface, top-side down.
Use a P5 Pentalobe driver to remove ten screws securing the lower case, of the following lengths:
Two 9 mm screws
Eight 2.6 mm screws

Traduire

Étape 2

Wedge your fingers between the display and the lower case and pull upward to pop the lower case off the Air.
Remove the lower case and set it aside.

Traduire

Étape 3 Battery Connector

MacBook Air 13" Early 2017 Right Speaker Replacement, Battery Connector: étape 3, image 1 de 2

MacBook Air 13" Early 2017 Right Speaker Replacement, Battery Connector: étape 3, image 2 de 2

To ensure that everything is de-energized and won't turn on while you're working, it is recommended that you disconnect the battery.
Grab the clear plastic pull tab attached to the battery connector and pull it parallel to the board toward the front edge of the Air.
Do not lift upward on the connector as you disconnect it or you risk damage to the connector socket.

Traduire

Étape 4 Battery

MacBook Air 13" Early 2017 Right Speaker Replacement, Battery: étape 4, image 1 de 1

Grab the clear plastic pull tab attached to the battery connector and pull it toward the front edge of the Air to disconnect the battery from the logic board.
Do not lift upward on the connector as you disconnect it.

Traduire

Étape 5

Remove the following five screws securing the battery to the upper case:
Three 6.3 mm T5 Torx screws
Two 2.4 mm T5 Torx screws

Traduire

Étape 6

When handling the battery, avoid squeezing or touching the four exposed lithium polymer cells.
Lift the battery from its edge nearest the logic board and remove it from the upper case.
If you're installing a new battery, you should calibrate it after installation:
Charge it to 100%, and then keep charging it for at least 2 more hours. Then, unplug and use it normally to drain the battery. When you see the low battery warning, save your work, and keep your laptop on until it goes to sleep due to low battery. Wait at least 5 hours, then charge your laptop uninterrupted to 100%.
If you notice any unusual behavior or problems after installing your new battery, you may need to reset your MacBook's SMC.