Aller au contenu principal

Table des matières

Wiki réalisé avec l'aide d'étudiants

Une formidable équipe d’étudiants de notre programme éducatif a créé ce wiki.

Fails To Charge

The speaker will either not charge or has a very short battery life.

Defective Charging Port

Often times, dust and debris get caught in the port and causes poor connection between the port and the adapter. You can clean out the port by blowing gently into the port opening to clear out dust. If this does not work, carefully try using a can of compressed air to clean it out.

Faulty Power Adapter

If the issue seems to lie with the power adapter, first check your power source (like the wall outlet) and make sure there is electricity present by plugging in a different device you know to be working. Also, check the cable or the connector for any visible damage. If it appears that the adapter is damaged, replace it with a new one.

Unreliable Battery

Over time, the battery may have deteriorated and therefore lost it's ability to hold a charge. If this is the case, follow this guide to replace your battery.

Distorted Audio

Audio coming from the speakers is distorted by static, clicking noises, or humming. Audio may also be hard or impossible to hear.

Bluetooth Not Connecting

Make sure the two devices are within Bluetooth range (average is 10 meters). If not, move them closer until they reconnect. If they do not reconnect and the connecting device is known to have working Bluetooth, the circuit board in the speaker may need to be replaced, which is explained in this guide, or the Bluetooth antenna may need replacing, which is shown in this guide.

Dirty Speakers

The speakers could be dirty or clogged with dust that could alter the sound quality. If this is the case, try gently wiping dust and dirt away with a non-alcohol based cleaner and a paper towel.

Broken Speakers

If there is no sound, the speakers are most likely broken, whether it is the speaker itself or because the rubber foam is damaged due to wear and tear or drying out. Both of these issues would cause distorted audio or no audio to be present. Follow this guide to replace the speakers. If the speakers seem to be in good condition (i.e. not damaged rubber), the problem is most likely in the circuit board. Follow this guide to replace the circuit board.

Control Buttons Do Not Work

One or more of the control buttons does not function (i.e. won't change volume, power on or off, connect to Bluetooth).

Faulty Buttons

One or more buttons is unresponsive and fails to operate correctly. It is likely to be a faulty control board, so to replace it, follow this guide.

Worn Out Buttons

Overuse of the buttons may cause them to wear out the rubber and therefore won't function correctly. The proper contact needed between the control board and the buttons is no longer there, so the rubber button ring would need replacing. Follow this guide to do so.

Alexandra Achtenberg

Membre depuis le 02/02/17

2 081 Réputation

6 tutoriels rédigés

Équipe

USF Tampa, Team 16-5, Blackwell Spring 2017 Membre de l'équipe USF Tampa, Team 16-5, Blackwell Spring 2017

USFT-BLACKWELL-S17S16G5

3 membres

24 tutoriels rédigés

76 commentaires

where is the actual guide?

Eric Yang - Réponse

Any idea of where I can get a replacement battery from?

Errik Kelly - Réponse

Press & Hold the bluetooth button on the speaker until it breaks the connection.It will make an audible tone

H.O. Pang, FCII - Réponse

Having issues with audio bluetooth dropping out and defaulting back to computer's audio

Kelly Rockett - Réponse

Speaker play fine.then cuts off. The power button continue to blink the whole time it's on.

Kevin Chillus -

Speaker work fine.But cut off about30 sec into playing .power button blinks the whole time .even after the stop.But never cut off power

Kevin Chillus -

Speaker plays then cuts off. Power button blinking red.

Holly Reese -

I have an onyx 2. It keeps asking for a pin number to connect to my laptop. I tried 0000 no luck. When I hold the BT button and + button it say 1 9 ? any help?

Carlos - Réponse

Operates while attached to charging unit but as soon as disconnected it stops. The unit is less than a year old, could it be faulty battery? And if so where or how can I replace the battery?

Steve Amelotte - Réponse

Have the same issue. Plays whilst plugged in but once it's on battery life it lasts all of 10 minutes. Device is about a year old. Got it last Xmas as a gift.

sunilvanmari -

Have the same issue. Device won't play for more than 10 mins on battery life. Got it as a gift last Xmas.

sunilvanmari -

Same here as well… I have 2 if them that are doing the same thing…. Frustrating

Rance D. Jordan -

I've only used my speaker three times and it's not coming on

Suzanne trotter - Réponse

My speaker will only connect for music when it’s connected to my laptop.  I have it connect to my tablet or phone and I can watch a movie or listen to music.  Any suggestions?

Traci Lester - Réponse

The power button keeps flashing for a couple seconds then it turns off

Tristan Flores - Réponse

Who can fix my Harmon kardon speaker it’s brand new used it a few times not getting any power to the speaker

Mario Singleton -

i have the same problem, ,any ideas on how to solve this?

angelo papastamos -

I have the same problem -o n a year old Onyx mini ?

deemaybe -

I’m having the same issue. Did u ever get it resolved?

NICHOLAS SARANT -

the speaker does not charger at all

paul - Réponse

i have the same %#*@ problem, ,any solutions?

angelo papastamos -

works well with my iphone even when phone are sleep, but distorted after several minutes with my macbook.. what’s wrong? thanks

teja hardy - Réponse

I’m having a similar problem. I’ve used my harman/kardon with my MacBook Pro daily, 8 to 10 hours a day, since I bought the speaker in February. Just this week, though, the audio with the speaker is distorted intermittently, whether I’m streaming from the web or playing tunes in my iTunes library. Haven’t tried it with the phone but will now. Anyone have a solution to this problem Teja and I share?

Susan Dooley -

Speaker plays for a few minutes then cuts off. Only played it a few times

Anthony Moore - Réponse

same here! it will play arround 1 to 2minutes and then no sound unles you press any keys and once you stop pressing the its dead

Aldes Lu -

The speaker fell once and now it doesn't turn on…Is there a reset button or something I can do to fix it.

Myra Pagan - Réponse

I sound like the others… but exactly the same thing happened to mine! Lol it fell, & now it sounds like $@$*. Reading all these probs makes me think h/k onyx is a lemon. cuz mine would only play music for 15 mins on a full charge. Very bummed out cuz it used to sound great! Anyways.. Jeff Riles~

P€∆¢€~

JEFF RILES -

The speaker fell to the floor and now it won't turn on. Is there a reset button.

Myra Pagan - Réponse

mine won’t connect to anything - not via bluetooth or an aux cord. Is this fixable? I tried resetting - it didn’t work.

Amanda Marek - Réponse

How do you reset it?

Robert Olivares -

my onyx 3 problem on ac mode if connect ac adapter my speaker it will mute sound and can't power on - off until disconnect ac adapter.

crissipper coyote - Réponse

M Harman/Kardon keeps disconnecting from my laptop. Seems that any sound makes it turn off.

tamiep - Réponse

Never mind, it was unplugged and the charge ran out. Duh!

tamiep - Réponse

My aura studio 2 keeps turning off and on and I can’t listen to my music

john.edgil1 - Réponse

My speaker light flashes constantly while plugged in to the wall outlet so I know it is getting power. The issue is when I use Bluetooth it will play for about thirty seconds then cut off what should I do?? Thank you in advance

Bob orender - Réponse

My speaker will cut off after 30 seconds of playtime while connected to Bluetooth I know it is getting power cause the power light flashes any help would be great thank you

Bob orender - Réponse

I´ve just noticed that the deep bass from one disappears when connecting two Onyx 3 with each other, which sucks!! Anyone here that knows how to fix that issue?

Martin Sandahl - Réponse

Where can I get the replacement battery for the Harmon Larson Onyx speaker?

Elvis Grant - Réponse

It’s connect but no sound unless you press a key then the sound comes as soon as you release the key then it goes off

charles darko - Réponse

same bro.. do you know what is the problem?

Aldes Lu -

Have you figured anything out?

Robert Olivares -

What if it makes a sound when turning it on and off, also when connecting it to Bluetooth. But everytime I play the music, I don’t hear anything. Please help me

Abriel Bernabe - Réponse

my onxy no sound…even starting tone…does anyone knows the clue

jalisatriani - Réponse

Mine is solve.. i put some metal to push on the rubber to lock the phone key to make a sounds.

Aldes Lu - Réponse

still no sound at all

jalisatriani -

My harman kardon onyx 2 I just turned it off after using it and then next day I tried to turn it on but it’s not working.. I also checked the adapter and it’s working.. So if u can tell me what is the issue with that is that bettery or charging port problem..

Noble Sampson - Réponse

My HK Onyx 4 isnt charging and when i plug in a service cable in it starts blinking red, anyone that knows why the speaker is doing that?

Alessandro Di Giulio - Réponse

I held the volume up and down for 10 seconds and now my Bluetooth light stood on and no devices were able to connect how do I fix that?

TheName1 - Réponse

Does a new battery need charging? And does the on/off button blink until the battery is fully charged?

sabotinman - Réponse

Nobody can explain why the Onyx 2 only works 30 seconds with or without the charger?? I ve had mine for three years. Started out perfectly but began to shutting down about a year ago. Any suggestions?

J.A. Boatwright - Réponse

i plugged the wrong charger into my speaker and now it smells burnt can someone please tell me what would have burnt out on circuit board

fabianpanelli - Réponse

I am so &&^&^$^ done with you and will tell everyone I know not to order your speaker. I have had problems but got no customer support. &&^& you. I will get another speaker.

bparenti4733 - Réponse

I have had problems with the speaker since I got it. I constantly have to reboot and now can’t get it to work at all. I will be looking to buy a different wireless speaker - this one is crap

bparenti4733 - Réponse

Mine won’t sound unless I press and hold a button ( +,- button or Bluetooth) either one of the 3

Robert Olivares - Réponse

I have to press any key to listen to music. If the button is not pressed cannot hear anything. Does anyone has a solution?

rd26_2000 - Réponse

My new onyx studio is not charging. It shows the red charging light for first 2 seconds and then turns off. Please help

Simar Bhamra - Réponse

My harman studio 2 speaker reaches maximum volume and then shuts off. Why??

Danny Coronado - Réponse

speaker cuts off when turned up

gwallace12 - Réponse

Hello, how can I equalize it? Too much bass

Rodrigo Díaz - Réponse

Press and hold Bluetooth and “-” buttons for 10 seconds then the device will toggle bass mode (2 modes)

Ludde Lund -

Will connect to Bluetooth but after 2 or 3 minutes will be disconnected to Bluetooth.

Cipriano Limlengco - Réponse

How do I know if the unit is charged

pg galwain - Réponse

I'm having a problem with the power up button (+). I had it on a shelf but the vibrations of the music managed to make it fall off and now the power up button won't work. Anyone know what I can do? Any suggestions would be very much appreciated. :)

Keyanna Lee - Réponse

My speaker battery has never charged. U unplug it and it shuts off since I have had it .

recently using it and the base gets so deep u can’t listen to it. Is there a reset that will help?

Ron

RON CROCE - Réponse

I can't get through an entire song, before it shuts off? What would cause that?

Le Staggers - Réponse

The speaker keeps turning off after about 20 seconds of play

Tony Jones - Réponse

Harmon carden Bluetooth speaker Onyx 2 power button blinks How do I fix it

Christopher Mir - Réponse

My speaker is keeps on and off itself. Though its either fully charge and/or lowbat. Annoying the on and off sound. Grrr

Chesna Blythe Toroba - Réponse

My HK Alexa cannot power up

Mischa 33D - Réponse

Can anyone assist ad to what I need to do I tried everything

The actual device had no power

Mischa 33D - Réponse

Red light comes in like its disscharged but it wont accept charge. Is there a fuse?

Kenneth B Way Sr. - Réponse

Sound goes in and out

Star Puttman - Réponse

I had my Onyx Studio 5 for 4 years and it broke down just now , Oct 2023….4 years old.. I checked everything and it is the IC ( Integrated circuitry inside which broke down.. no replacement available in the current market.. for its price ?? .. my cheap Brookstone Bluetooth still runs good and it is now 7 yrs old…

Joe Lim - Réponse

Mine will not turn on at all

Tattoo Cr - Réponse

High pitched squeal as soon as I turn it on and continues while playing music hk onyx 2

Medusa Graves - Réponse

Thank you so much! There was a high vibrating noise and it's now back to normal after cleaning with window cleaner and a paper towel :-)

Anita Rick - Réponse

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 1

7 derniers jours : 37

30 derniers jours : 192

Total : 145,326